SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1060 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSPRING BUMPER REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the spring bumper to the mounting cup. For 4WD 15-Series and 2WD 25/35-Series.
    Fig 1: Snapping The Spring Bumper To The Mounting Cup (4WD 15-Series and 2WD 25/35-Series)
    GM348563Courtesy of GENERAL MOTORS CORP.
    2. Fig 2: Installing The Spring Bumper (4WD 15-Series and 2WD 25/35-Series)
    GM348561Courtesy of GENERAL MOTORS CORP.
  2. Install the spring bumper. For 4WD 15-Series and 2WD 25/35-Series.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the nut to the spring bumper stud.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  4. Remove the safety stands.
  5. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.