Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1028 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER ARM REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Position the wiper arm so that the wiper blade aligns with the mark made on the windshield before removal.
- Install the wiper arm onto the drive shaft.
- Install the nut on the drive shaft.
Tighten: Tighten the nut to 30 N.m (22 lb ft).
- Install the cover on the nut.
- Connect the washer hose.
- Clean the locating mark or masking tape from the windshield.
- Operate the wipers and inspect for proper operation.
NOTE:
Refer toFastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.