SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1022 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSCOOLANT PUMP - STARTER/GENERATOR CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the SGCM coolant pump inlet hose (4) to the SGCM coolant pump (2).
  2. Position the SGCM coolant pump inlet hose clamp (1) to the SGCM coolant pump (2).
    3. Fig 1: View Of Coolant Pump Inlet Hose, Clamp & Pump
    GM1206695Courtesy of GENERAL MOTORS CORP.
  3. Position the SGCM coolant pump outlet hose clamp (2) to the SGCM coolant pump (1).
  4. Install the SGCM coolant pump outlet hose (3) to the SGCM coolant pump (1).
    5. Fig 2: View Of SGCM Coolant Pump, Outlet Hose Clamp & Hose
    GM1206677Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (1) to the SGCM coolant pump (2).
    6. Fig 3: View Of SGCM Coolant Pump & Electrical Connector
    GM1285623Courtesy of GENERAL MOTORS CORP.
  6. Position the SGCM coolant pump (1) to the radiator core support (3).
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the bolts (2) to the SGCM coolant pump (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    8. Fig 4: View Of SGCM Coolant Pump, Bolts & Radiator Core Support
    GM1206679Courtesy of GENERAL MOTORS CORP.
  8. Install the push pin to the right side radiator air baffle.
  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.3L.
    10. NOTE: The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing starter/generator control module damage.
  10. Fill the SGCM cooling system. Refer to Draining and Filling Cooling System - Starter/Generator Control Module .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.