Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1001 (WIRING SYSTEMS (COMPONENT LOCATOR))COMPONENT LOCATORPOWER AND GROUNDING COMPONENT VIEWS
2004 Oldsmobile Bravada RWD
Power and Grounding Component Views
2004 Oldsmobile Bravada RWDSECTION Power and Grounding Component Views
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | LH Lower Radiator Support |
| 2 | Forward Lamp Harness |
| 3 | Negative Battery Cable (G100) |
| 4 | Frame |
| 5 | Ground 100 (G100) |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block-Underhood Bracket |
| 2 | I/P Harness |
| 3 | Radiator Support |
| 4 | Inline Connector C103 or C104-I/P Harness Side |
| 5 | Inline Connector C103 or C104-Forward Lamp Harness Side |
| 6 | LH Battery Tray |
| 7 | Fuse Block-Underhood Bracket |
| 8 | Fuse Block-Underhood Bracket |
| Callout | Component Name |
|---|---|
| 1 | Starter |
| 2 | G102 |
| 3 | Crankshaft Position (CKP) Sensor Connector |
| 4 | Negative Battery Cable |
| Callout | Component Name |
|---|---|
| 1 | Camshaft Position (CMP) Sensor Connector |
| 2 | Engine Oil Pressure (EOP) Sensor Connector |
| 3 | G103 |
| 4 | G104 |
| 5 | Ground Strap |
| 6 | Knock Sensor (KS) Connector |
| Callout | Component Name |
|---|---|
| 1 | Engine Oil Pressure (EOP) Sensor Connector |
| 2 | G103 |
| 3 | Camshaft Position (CMP) Sensor Connector |
| 4 | G104 |
| Callout | Component Name |
|---|---|
| 1 | Engine Coolant Temperature (ECT) Sensor Connector |
| 2 | G102 |
| 3 | Negative Battery Cable |
| Callout | Component Name |
|---|---|
| 1 | G103 |
| 2 | Engine Block |
| 3 | G102 |
| 4 | G109 |
| Callout | Component Name |
|---|---|
| 1 | Engine Block |
| 2 | G108 |
| 3 | G104 |
| Callout | Component Name |
|---|---|
| 1 | Engine-8.1L |
| 2 | Engine Knock Sensor (KS) - 2 |
| 3 | Engine Knock Sensor (KS) - 2 Connector |
| 4 | Engine Harness |
| 5 | G102-Engine Harness Ground |
| Callout | Component Name |
|---|---|
| 1 | G104 |
| 2 | Engine |
| 3 | Engine Oil Pressure (EOP) Sensor Connector |
| 4 | Ground Strap |
| 5 | Crankshaft Position (CKP) Sensor Connector |
| 6 | G103 |
| Callout | Component Name |
|---|---|
| 1 | G106 (Engine Harness) |
| 2 | G106 (Battery Cable) |
| 3 | Back of Engine Block |
| Callout | Component Name |
|---|---|
| 1 | Starter/Generator Control Module Bracket |
| 2 | Starter/Generator Control Module |
| 3 | Dash Panel |
| 4 | G120 |
| 5 | Starter/Generator Control Module Coolant Hose |
| Callout | Component Name |
|---|---|
| 1 | Engine Block |
| 2 | G121 |
| 3 | Electro Hydraulic Power Steering (EHPS) 42V Harness |
| Callout | Component Name |
|---|---|
| 1 | Electro Hydraulic Power Steering (EHPS) Module Assembly |
| 2 | G122 |
| 3 | Water Pump |
| Callout | Component Name |
|---|---|
| 1 | Instrument Panel |
| 2 | G200 |
| 3 | Ground Stud |
| Callout | Component Name |
|---|---|
| 1 | Junction Block - I/P |
| 2 | Instrument Panel |
| Callout | Component Name |
|---|---|
| 1 | Relay Block - I/P |
| 2 | Relay Block - I/P - C4 |
| 3 | C210 - Roof Beacon Relay Inline |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Left I/P |
| 2 | Instrument Panel |
| 3 | Body Control Module (BCM) |
| 4 | Body Harness to Body Control Module (BCM) |
| Callout | Component Name |
|---|---|
| 1 | Steering Wheel Audio Controls - Left |
| 2 | Passlock Sensor Connector |
| 3 | Ignition Key Alarm Switch |
| 4 | Ignition Lock Cylinder Control Actuator |
| 5 | Ignition Lock Cylinder Control Actuator Connector |
| 6 | Ignition Switch |
| 7 | Ignition Key Cylinder |
| 8 | Steering Wheel Audio Controls - Right |
| 9 | Horn Switch |
| 10 | Steering Wheel Driver Information (DIC) Controls - Right |
| 11 | C277 |
| 12 | Steering Wheel Driver Information Center (DIC) Controls - Left |
| 13 | Turn Signal/Multifunction Switch |
| Callout | Component Name |
|---|---|
| 1 | Upper Plenum |
| 2 | G203 |
| Callout | Component Name |
|---|---|
| 1 | Left Front Body Mount |
| 2 | G110 |
| 3 | G302 (10 Series) |
| Callout | Component Name |
|---|---|
| 1 | Fuel Pump and Sender Assembly |
| 2 | Fuel Tank |
| 3 | Frame |
| 4 | G302 |
| 5 | Evaporative Emission (EVAP) Canister Purge Solenoid |
| Callout | Component Name |
|---|---|
| 1 | C396 (Crew Cab) |
| 2 | G306 |
| 3 | G304 |
| 4 | C399 |
| 5 | RH B-Pillar |
| Callout | Component Name |
|---|---|
| 1 | G305 |
| 2 | LH B-Pillar |
| 3 | C305 |
| 4 | Inflatable Restraint Sensing and Diagnostic Module (SDM) |
| Callout | Component Name |
|---|---|
| 1 | Energy Storage Control Module (ESCM) |
| 2 | 400A Fuse Holder |
| 3 | Energy Storage Box (ESB) Cooling Fan |
| 4 | Battery Cut Off |
| 5 | Voltage Sensor - 1 |
| 6 | Temperature Sensor - Battery 1 |
| 7 | C340 |
| 8 | Battery 1 |
| 9 | Voltage Sensor - 2 |
| 10 | Temperature Sensor - Battery 2 |
| 11 | Battery 2 |
| 12 | Current Sensor |
| 13 | Auxiliary Power Outlet |
| 14 | Voltage Sensor - 3 |
| 15 | Temperature Sensor - Battery 3 |
| 16 | Battery 3 |
| 17 | Voltage Sensor - 4 |
| 18 | Auxiliary Power Outlet Connector |
| 19 | C341 |
| 20 | Service Disconnect Switch |
| 21 | G311 |
| 22 | G310 |
| Callout | Component Name |
|---|---|
| 1 | Frame |
| 2 | Fuel Tank |
| 3 | Rear Differential |
| 4 | G401 |
| Callout | Component Name |
|---|---|
| 1 | Electronic Brake Control Module (EBCM) |
| 2 | Chassis Harness |
| 3 | G403 |
| Callout | Component Name |
|---|---|
| 1 | Spare Tire Carrier Bracket |
| 2 | Rear EPTO Outlet Connector |
| 3 | G405 |
| 4 | Frame |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.