SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1000 (BATTERY, CHARGING SYSTEM & STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR BRACKET REPLACEMENT (8.1L ENGINE)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the generator bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket stud.

    Tighten:  Tighten the stud to 20 N.m (15 lb ft).

  3. Install the generator bracket bolts and nut.

    Tighten:  Tighten the bolts and nut to 50 N.m (37 lb ft)

    4. Fig 1: View Of Generator Bracket & Bolts (8.1L)
    GM751458Courtesy of GENERAL MOTORS CORP.
  4. Install the generator. Refer to Generator Replacement (4.3L Engine)  or Generator Replacement (4.8L, 5.3L, and 6.0L Engines)  or Generator Replacement (6.6L (LB7) Engine)  or Generator Replacement (6.6L (LLY) Engine)  or Generator Replacement (8.1L Engine) .
  5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement in Engine Mechanical - 8.1L.
  6. Install the fan and clutch. Refer to Fan Clutch Replacement in Engine Cooling.
  7. Install the battery cable junction block bracket bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    8. Fig 2: View Of Battery Cable Junction Block Bracket Bolts (8.1L Engine)
    GM759640Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.