Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 997 (ENGINE CONTROLS - 4.3L (INTRODUCTION))COMPONENT LOCATORENGINE CONTROLS CONNECTOR END VIEWS
2004 Oldsmobile Bravada AWD
Engine Controls Connector End Views
2004 Oldsmobile Bravada AWDSECTION Engine Controls Connector End Views
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Camshaft Position (CMP) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | PNK/BLK | 632 | Low Reference |
| B | BRN/WHT | 633 | CMP Sensor Signal |
| C | RED | 631 | 12 Volt Reference |
Ignition Control Module (ICM) Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | PNK | 1039 | Ignition 1 Voltage |
| B | WHT | 423 | IC Timing Control |
| C | BLK | 550 | Ground |
| D | WHT/BLK | 1847 | Ignition Coil Control |
Crankshaft Position (CKP) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | LT GRN | 1867 | 12 Volt Reference |
| B | YEL/BLK | 1868 | Low Reference |
| C | DK BLU/WHT | 1869 | CKP Sensor Signal |
Engine Coolant Temperature (ECT) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | BLK | 407 | Low Reference |
| 2 | YEL | 410 | ECT Sensor Signal |
Evaporative Emission (EVAP) Canister Purge Solenoid Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | PNK | 439 | Ignition 1 Voltage |
| B | DK GRN/WHT | 428 | EVAP Canister Purge Solenoid Control |
Evaporative Emission (EVAP) Canister Vent Solenoid Terminal Identification (w/EVA)
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | WHT | 1310 | EVAP Canister Vent Solenoid Control |
| B | PNK | 2640 | Battery Positive Voltage |
Fuel Injector Assembly Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | BLK/WHT | 845 | Fuel Injector 5 Control |
| B | PNK | 1039 | Ignition 1 Voltage |
| C | PNK/BLK | 1746 | Fuel Injector 3 Output |
| D | PNK | 1039 | Ignition 1 Voltage |
| E | PNK | 1039 | Ignition 1 Voltage |
| F | BLK | 1744 | Fuel Injector 1 Control |
| G | LT GRN/ BLK |
1745 | Fuel Injector 2 Control |
| H | PNK | 1239 | Ignition 1 Voltage |
| J | PNK | 1239 | Ignition 1 Voltage |
| K | LT BLU/ BLK |
844 | Fuel Injector 4 Control |
| L | PNK | 1239 | Ignition 1 Voltage |
| M | YEL/BLK | 846 | Fuel Injector 6 Control |
Fuel Tank Pressure (FTP) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | BLK | 470 | Low Reference |
| B | DK GRN | 890 | Fuel Tank Pressure Sensor Signal |
| C | GRY | 474 | 5 Volt Reference |
Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1 Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | TAN | 1664 | HO2S Low Signal - Bank 1 Sensor 1 |
| B | PPL/WHT | 1665 | HO2S High Signal - Bank 1 Sensor 1 |
| C | BLK/WHT | 3113 | HO2S Heater Low Control - Bank 1 Sensor 1 |
| D | PNK | 539 | Ignition 1 Voltage |
Heated Oxygen Sensor (HO2S) Bank 1 Sensor 2 Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | TAN/WHT | 1669 | HO2S Low Signal - Bank 1 Sensor 2 |
| B | PPL/WHT | 1668 | HO2S High Signal - Bank 1 Sensor 2 |
| C | BRN | 2391 | HO2S Heater Low Control - Bank 1 Sensor 2 |
| D | PNK | 1539 | Ignition 1 Voltage |
Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1 Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | TAN | 1667 | HO2S Low Signal - Bank 2 Sensor 1 |
| B | PPL | 1666 | HO2S High Signal - Bank 2 Sensor 1 |
| C | LT GRN | 3212 | HO2S Heater Low Control - Bank 2 Sensor 1 |
| D | PNK | 539 | Ignition 1 Voltage |
Heated Oxygen Sensor (HO2S) Bank 2 Sensor 2 Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | TAN | 1671 | HO2S Low Signal - Bank 2 Sensor 2 |
| B | PPL | 1670 | HO2S High Signal - Bank 2 Sensor 2 |
| C | RED/WHT | 3223 | HO2S Heater Low Control - Bank 2 Sensor 2 |
| D | PNK | 1539 | Ignition 1 Voltage |
Idle Air Control (IAC) Valve Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | LT GRN/BLK | 444 | IAC Coil B Low Control |
| B | LT GRN/WHT | 1749 | IAC Coil B High Control |
| C | LT BLU/BLK | 1748 | IAC Coil A Low Control |
| D | LT BLU/WHT | 1747 | IAC Coil A High Control |
Ignition Coil Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | PNK | 1239 | Ignition 1 Voltage |
| B | - | - | Not Used |
| C | WHT/BLK | 1847 | Ignition Coil Control |
Intake Air Temperature (IAT)/Mass Air Flow (MAF) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | BLK | 552 | Low Reference |
| B | TAN | 472 | IAT Sensor Signal |
| C | BLK/WHT | 451 | Ground |
| D | PNK | 439 | Ignition 1 Voltage |
| E | YEL | 492 | MAF Sensor Signal |
Knock Sensor (KS) Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | DK BLU | 496 | Knock Sensor Signal |
| B | GRY | 1716 | Low Reference |
Manifold Absolute Pressure (MAP) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | ORN/BLK | 469 | Low Reference |
| B | LT GRN | 432 | MAP Sensor Signal |
| C | GRY | 597 | 5 Volt Reference |
Throttle Position (TP) Sensor Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | GRY | 2701 | 5 Volt Reference |
| 2 | BLK | 2752 | Low Reference |
| 3 | DK BLU | 417 | TP Sensor Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.