Cellular Communication Connectors

2004 Oldsmobile Bravada AWDSECTION Cellular Communication Connectors
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle Communication Interface Module (VCIM) - C1

GM697022Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 15383038
  • 16-Way F Multi-lock (WHT)
Pin Wire Color Circuit No. Function
1 - - Not Used
2 BRN/WHT 2517 Keypad Red LED Signal
3 YEL/BLK 2516 Keypad Green LED Signal
4-5 - - Not Used
6 LT GRN/BLK 2515 Keypad Supply Voltage
7 BLK/WHT 1851 Ground
8 BLK/WHT 1851 Ground
9-10 - - Not Used
11 DK GRN/WHT 2514 Keypad Signal
12-14 - - Not Used
15 ORN 3240 Battery Positive Voltage
16 ORN 3240 Battery Positive Voltage
Vehicle Communication Interface Module (VCIM) - C2

GM697023Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 15383039
  • 12-Way F Multi-lock (WHT)
Pin Wire Color Circuit No. Function
1 PNK/BLK 2062 Cellular Telephone Voice Signal
2 ORN/BLK 2061 Cellular Telephone Voice Low Reference
3-4 - - Not Used
5 YEL 1127 Trip Computer/Nav Class 2 Serial Data
6-7 - - Not Used
8 BARE 1792 Drain Wire
9 GRY 655 Cellular Microphone Signal
10 BARE 514 Drain Wire
11-12 - - Not Used
Cellular Microphone

GM82383Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12047662
  • 2-Way F Metri-Pack 150 Series (BLK)
Pin Wire Color Circuit No. Function
A BARE 514 Drain Wire
B GRY 655 Cellular Microphone Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.