SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 964 (TRANSFER CASE (NVG126-NP4))REPAIR INSTRUCTIONSTRANSFER CASE SPEED SENSOR REPLACEMENT (RIGHT REAR)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transfer case right rear speed sensor.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Tighten 

    Tighten the transfer case right rear speed sensor to 20 N.m (15 lb ft).

    2. Fig 1: Installing Transfer Case Right Rear Speed Sensor
    G01705584Courtesy of GENERAL MOTORS CORP.
  2. Install the transfer case right rear speed sensor electrical connector.
  3. Install the fuel tank shield.
  4. Install the fuel tank mounting bolts

    Tighten 

    Tighten the fuel tank mounting bolts to 25 N.m (18 lb ft).

    5. Fig 2: Installing Fuel Tank Mounting Bolts
    G01705585Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.