Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.
- Install the motor/encoder to the transfer case.
- Install the motor/encoder gasket to the transfer case.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install motor/encoder mounting bolts to the transfer case.
Tighten
Tighten the motor/encoder mounting bolts to 20 N.m (15 lb ft).
- Install the motor/encoder electrical connector.
- Install the transfer case shield. Refer to TRANSFER CASE SHIELD REPLACEMENT .
- Lower the vehicle. Refer to JACKING AND LIFTING in General Information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.