Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Setting DTC
If the ECM detects a temperature difference between the ECT sensor and the IAT sensor of more than 252°F (140°C) at start up; or the time spent cranking the engine, without starting is more than 10 seconds with a temperature difference between the ECT sensor and the IAT sensor of more than 36°F (20°C); or if the PCM detects a temperature between the ECT sensor and the IAT sensor of more than 36°F (20°C), then the vehicle must be driven for 5 minutes over 15 MPH. If the IAT sensor temperature decreases more than 12.6°F (7°C) then a block heater is detected and the test is aborted. If the IAT sensor temperature does not decrease, then a block heater was not detected and DTC P0116 sets.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.