Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 899 (INSTRUMENT PANEL, GAGES, AND CONSOLE)
2004 Oldsmobile Bravada AWD
Section 899 (Instrument Panel, Gages, And Console)
2004 Oldsmobile Bravada AWDSECTION Section 899 (Instrument Panel, Gages, And Console)
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Instrument Panel, Gages and Console
- Diagnostic System Check - Instrument Cluster
- Diagnostic System Check - Head Up Display
- Diagnostic System Check - Audible Warnings
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B1369: Ignition 0 Input Is Low
- DTC B2823 or B3574: Trip Odometer Reset Switch Signal Circuit Is Low
- DTC B2838, B3564, B3569 Or B3752: Reset/Mode Switch Signal Circuit Low
- DTC B2961: Ignition 0 Input Is Active
- DTC P0462: Fuel Level Signal Low
- DTC P0463: Fuel Level Signal High
- DTC P1189: Engine Oil Pressure Switch Signal Circuit Is Low
- Symptoms - Instrument Panel, Gages & Console
- Engine Coolant Temperature Gage Inaccurate Or Inoperative
- Fuel Gage Inaccurate or Inoperative
- Odometer Trip/Reset Switch Inoperative
- Speedometer And/Or Odometer Inaccurate Or Inoperative
- Tachometer Inaccurate Or Inoperative
- Change Engine Oil Indicator Always On
- Change Engine Oil Indicator Inoperative
- Low Engine Oil Level Indicator Always On
- Drive Information Center Temperature Display Always Reads SC
- Drive Information Center Temperature Display Always Reads OC
- Drive Information Center (DIC) Compass Inaccurate Or C Displayed
- Drive Information Center (DIC) Switch(es) Inoperative
- Outside Air Temperature Display Inaccurate or Inoperative
- Head Up Display (HUD) Inoperative
- Head Up Display (HUD) Turn Signal Inoperative (Left/Right)
- Head Up Display (HUD) Image Adjustment Inoperative
- Head Up Display (HUD) Intensity Does Not Vary
- Chime Always On
- Chime Inoperative
- Repair Instructions
- Ambient Air Temperature Gage Sensor Replacement (Aztek)
- Ambient Air Temperature Gage Sensor Replacement (Rendezvous)
- Instrument Panel (I/P) Multifunction Switch Assembly Replacement
- Electronic Compass Calibration
- Head Up Display Switch Replacement (Rendezvous)
- Head Up Display Switch Replacement (Aztek)
- Head Up Display Module Replacement
- Closeout/Insulator Panel Replacement - Right
- Closeout/Insulator Panel Replacement - Left
- Knee Bolster Replacement
- Trim Plate Replacement - Instrument Panel (I/P) Accessory (Aztek)
- Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek)
- Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous)
- Instrument Panel (I/P) Outer Trim Cover Replacement
- Compartment Replacement - Instrument Panel (I/P)
- Striker Replacement - Instrument Panel (I/P) Compartment
- Handle Replacement - Instrument Panel (I/P) Compartment (Aztek)
- Handle Replacement - Instrument Panel (I/P) Compartment (Rendezvous)
- Lock Cylinder Replacement - Instrument Panel (I/P) Compartment
- Instrument Panel (I/P) Assist Handle Replacement
- Trim Pad Replacement - Instrument Panel (I/P) Upper (Aztek)
- Trim Pad Replacement - Instrument Panel (I/P) Upper (Rendezvous)
- Driver Information Center Switch Replacement (Rendezvous)
- Driver Information Center Switch Replacement (Aztek)
- Instrument Panel Cluster (IPC) Replacement
- Accessory Power Receptacle Replacement - 12 Volt
- Cigar Lighter Housing Replacement - Instrument Panel (I/P)
- Instrument Panel (I/P) Assembly Replacement
- Instrument Panel (I/P) Carrier Replacement
- Latch Replacement - Console Compartment Door (Rendezvous)
- Trim Plate Replacement - Console Rear (Rendezvous).
- Console Replacement - Front Floor (Aztek)
- Console Replacement - Front Floor (Rendezvous)
- Bracket Replacement - Console Floor
- Console Armrest Replacement - Front Floor (Rendezvous)
- Trim Plate Replacement - Front Floor Console (Aztek).
- Trim Plate Replacement - Front Floor Console (Rendezvous)
- Accessory Power Receptacle Replacement - Floor Console
- Description and Operation
- Special Tools & Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.