SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 889 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSON-VEHICLE REPAIR INSTRUCTIONSENGINE MOUNT BRACKET REPLACEMENT (AWD)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount bracket to the engine mount.
  2. Install the engine mount upper nuts.

    Tighten 

    Tighten the engine mount upper nuts to 53 N.m (39 lb ft).

  3. Use a utility stand in order to lower the engine.
    Fig 1: Installing Engine Mount Bracket To Engine Mount - AWD
    G01500435Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount bracket to the oil pan.
  5. Install the engine mount bracket-to-oil pan bolts.

    Tighten 

    • Tighten the engine mount bracket to oil pan bolts (1) to 58 N.m (43 lb ft).
    • Tighten the upper bracket to engine block bolt (2) to 85 N.m (63 lb ft).
  6. Install the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT -- ENGINE .
  7. Install the right front wheel and tire.
  8. Connect the catalytic converter pipe to the engine right side exhaust manifold.
  9. Lower the vehicle.
    Fig 2: Installing Engine Mount Bracket-To-Oil Pan Bolts - AWD
    G01500436Courtesy of GENERAL MOTORS CORP.
  10. Install the engine mount struts. Refer to ENGINE MOUNT STRUT REPLACEMENT - LEFT  and ENGINE MOUNT STRUT REPLACEMENT - RIGHT  .
  11. Install the throttle body air inlet duct.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.