Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Front Cover Installation
- Install the engine front cover gasket.
- Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or equivalent to both sides of the lower tabs of the engine front cover gasket, and the engine front cover bolts.
- Install the engine front cover.
- Install the engine front cover bolts (2).
Tighten Tighten the engine front cover bolts (2) to 55 N.m (41 lb ft).
- Install the engine front cover bolts (3).
Tighten Tighten the engine front cover bolts (3) to 55 N.m (41 lb ft).
- Install the engine front cover bolts (1).
Tighten Tighten the engine front cover bolts (1) to 27 N.m (20 lb ft).
- Install the crankshaft position sensor wiring bracket.
- Install the crankshaft position sensor wiring bracket bolt.
Tighten Tighten the crankshaft position sensor wiring bracket bolt to 27 N.m (20 lb ft).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.