Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the auxiliary HVAC control assembly to the overhead console.
  2. Connect the electrical connectors to the auxiliary HVAC control assembly.
  3. Install the overhead console to the headliner.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the overhead console screw.

    Tighten 

    Tighten the screw to 2 N.m (18 lb in).

    Fig 1: Installing HVAC Control Assembly - Front Auxiliary (Front Overhead Control A/C Only)
    G01454648Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.