SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 862 (HVAC SYSTEMS - AUTOMATIC)DESCRIPTION AND OPERATIONHVAC CONTROL COMPONENTSAUTOMATIC OPERATION
2004 Oldsmobile Bravada AWD

Automatic Operation

2004 Oldsmobile Bravada AWDSECTION Automatic Operation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

In automatic operation, the HVAC control module will maintain the comfort level inside of the vehicle by controlling the A/C compressor clutch, the blower motor, the air temperature actuators, mode actuator and recirculation.

To place the HVAC system in Automatic mode, the following is required:

  • The Auto switch must be activated
  • The air temperature switch must be in any other position other than full hot or full cold position

Once the desired temperature is reached, the blower motor, mode, recirculation and temperature actuators will automatically be adjusted to maintain the temperature selected. The HVAC control module performs the following functions to maintain the desired air temperature:

  • Monitor the following sensors:
    • Inside air temperature sensor
    • Ambient Air Temperature Sensor
    • Lower Left Air Temperature Sensor
    • Lower Right Air Temperature Sensor
    • Upper Left Air Temperature Sensor
    • Upper Right Air Temperature Sensor
  • Regulate blower motor speed
  • Position the air temperature actuator
  • Position the mode actuator
  • Position the recirculation actuator
  • Request A/C operation

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.