SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 85 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 8.1L)DIAGNOSTIC TESTSDTC P0106: MAP SYSTEM PERFORMANCECONDITIONS FOR RUNNING DTC
2004 Oldsmobile Bravada AWD

Conditions For Running DTC

2004 Oldsmobile Bravada AWDSECTION Conditions For Running DTC
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Sierra, 2002 GMC Savana Special, 2002 GMC Savana Camper Special, and 2002 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
  • DTCs P0101, P0102, P0103, P0107, P0108, P0401, P0404, P0405, P0410, P0440, P0442, P0443, P0446, P1120, P1125, P1220, P1221, P1275, P1276, P1280, P1281, P1285, P1286, P1514, P1515, P1516, P1517, or P1518 are not set.
  • The engine is running.
  • The engine speed is between 400-5000 RPM.
  • The change in engine speed is less than 125 RPM.
  • The traction control is not active.
  • A change in idle air is less than 10 g/s.
  • A change in the Exhaust Gas Recirculation (EGR) position is less than 20 percent.
  • The A/C compressor clutch is steady.
  • The power steering is stable.
  • The Power Take-Off (PTO) is not active.
  • The clutch switch state does not change.
  • The brake switch state does not change.
  • All conditions are stable for 1 second.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.