SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 846 (BODY REAR END)REPAIR INSTRUCTIONSWINDOW REPLACEMENT - LIFT GATEINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Close the liftgate.
  2. With an assistant, install the liftgate window to the liftgate by locating on pins and sliding to the right.
    3. Fig 1: Installing Liftgate Window Struts
    G01459514Courtesy of GENERAL MOTORS CORP.
  3. Open the liftgate.
  4. With an assistant, install the new liftgate window hinge pin retainers. Close the liftgate and open and support liftgate window.
  5. Install the liftgate window struts. Refer to STRUT REPLACEMENT - LIFT GATE WINDOW  .
  6. Connect the liftgate window defogger electrical connectors, if equipped.
  7. Remove the support and close window.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.