SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 846 (BODY REAR END)REPAIR INSTRUCTIONSEND GATE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate.
  2. Remove the theft deterrent bolt.
    3. Fig 1: Removing Theft Deterrent Bolt
    G01459423Courtesy of GENERAL MOTORS CORP.
  3. With an assistant, raise the endgate to a 45 degree angle.
  4. Remove the cable on each side from the side panel striker bolts.
  5. Remove the endgate from the right side hinge assembly by lifting up on the right side.
    6. Fig 2: Removing Endgate From Right Side Hinge Assembly
    G01459424Courtesy of GENERAL MOTORS CORP.
  6. With an assistant, remove the endgate from the left body side hinge by sliding to the right and lifting.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.