SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 807 (INTERIOR TRIM)CONSOLE REMOVAL/INSTALLATION
2004 Oldsmobile Bravada AWD

Console Removal/Installation

2004 Oldsmobile Bravada AWDSECTION Console Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach clips A, B and C and remove the upper panel.
    Fig 1: Removing Console Upper Panel
    G02566799Courtesy of MAZDA MOTORS CORP.
  2. Detach clips D, E and F and remove the boot panel.
    Fig 2: Removing Console Boot Panel
    G02566800Courtesy of MAZDA MOTORS CORP.
  3. Remove screws A.
  4. Detach clips G.
  5. Disconnect the cigarette lighter connector.
  6. Remove the ashtray illumination, then remove the ashtray panel.
    Fig 3: Removing Ashtray Panel
    G02566801Courtesy of MAZDA MOTORS CORP.
  7. Remove the screws B.
  8. Detach tabs H and remove the console.
  9. Install in the reverse order of removal.
    Fig 4: Removing Console
    G02566802Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.