Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 800 (MANUAL TRANSAXLE CLUTCH)CLUTCH UNIT REMOVAL/INSTALLATIONFLYWHEEL INSTALLATION NOTE
2004 Oldsmobile Bravada AWD
Flywheel Installation Note
2004 Oldsmobile Bravada AWDSECTION Flywheel Installation Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Install the flywheel to the crankshaft.
- When reusing the bolts, clean threads and hole, then apply locking compound to the threads.NOTE:
- No locking compound is needed when using new bolts.
- Hand-tighten the flywheel lock bolts.
- Install the SST to the flywheel.
- Gradually tighten the flywheel lock bolts in a crisscross pattern.
- Tightening torque 108-116 N.m 11.1-11.8 kgf.m, 79.7-85.5 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.