Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 797 (DOORS AND LIFTGATE)LIFTGATE REMOVAL/INSTALLATIONNOTES

2004 Oldsmobile Bravada AWD

Liftgate Removal/Installation: Notes

2004 Oldsmobile Bravada AWDSECTION Notes

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Removing the stay damper without supporting the liftgate can be dangerous. The liftgate may fall and injure you. Always perform the following procedure with at least another person.

Disconnect the negative battery cable.
Remove the trunk side upper trims. (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
Remove the C-pillar trims. (See C-PILLAR TRIM REMOVAL/INSTALLATION .
Remove the fasteners on the rear part of the headliner and disconnect the following parts while partially peeling back the headliner.
- Rear washer hose
- Liftgate wiring harness connector
Remove the grommets from the liftgate.

Remove in the order indicated in the table.

Fig 1: Liftgate With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

REMOVAL ORDER OF LIFTGATE

Removal Order	Part
1	Stay damper (See Stay Damper Removal Note .)
2	Bolt
3	Liftgate
4	Nut
5	Liftgate hinge

Install in the reverse order of removal.
Adjust the liftgate. (See LIFTGATE ADJUSTMENT .)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.