SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 771 (ENGINE MECHANICAL - 3.1L (UNIT REPAIR))REPAIR INSTRUCTIONSENGINE FRONT COVER INSTALLATION
2004 Oldsmobile Bravada AWD

Engine Front Cover Installation

2004 Oldsmobile Bravada AWDSECTION Engine Front Cover Installation
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine front cover gasket.
  2. Apply sealer GM P/N United States 12346004, GM P/N Canada 10953480 or the equivalent to both sides of the lower tabs of the engine front cover gasket.
    Fig 1: Applying Sealer To Engine Front Cover Gasket
    G01811237Courtesy of GENERAL MOTORS CORP.
  3. Install the engine front cover.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the engine front cover bolts (3).

    Tighten 

    Tighten the bolts (3) to 55 N.m (41 lb ft).

  5. Install the engine front cover bolt (1).

    Tighten 

    Tighten the bolt (1) to 55 N.m (41 lb ft).

  6. Install the engine front cover bolts (2).

    Tighten 

    Tighten the bolts (2) to 27 N.m (20 lb ft).

    Fig 2: Installing Engine Front Cover
    G01811238Courtesy of GENERAL MOTORS CORP.
  7. Install the crankshaft position sensor wiring bracket.
  8. Install the crankshaft position sensor wiring bracket bolt.

    Tighten 

    Tighten the crankshaft position sensor wiring bracket bolt to 40 N.m (30 lb ft).

Fig 3: Installing Crankshaft Position Sensor Wiring Bracket
G01811239Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.