Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
10 Minute Learn Procedure
2004 Oldsmobile Bravada AWDSECTION 10 Minute Learn Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- Tech 2
- Techline terminal with current (SPS) Service Programming System software
- Connect the Tech 2 to the vehicle.
- Select "Request Information" under "Service Programming".
- Disconnect the Tech 2 from the vehicle and connect it to a techline terminal.
- On the techline terminal, select "Theft Module Re-Learn" under "Service Programming".
- Disconnect the Tech 2 from the techline terminal and connect it to the vehicle.
- Turn ON the ignition, with the engine OFF.
- Select "VTD Re-Learn" under "Service Programming".
- Attempt to start the engine, then release the key to ON, vehicle will not start.
- Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF, the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK.
- Turn OFF the ignition, and wait 5 seconds.
- Start the engine, the vehicle has now learned the password.
- With the Tech 2 (scan tool), clear any DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.