Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Running DTC
2004 Oldsmobile Bravada AWDSECTION Conditions For Running DTC
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Sonoma, 2002 GMC Safari, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- No MAP sensor DTCs P0107 or P0108.
- No TP sensor DTCs P0122 or P0123.
- No TFP manual valve position switch DTC P1810.
- The engine vacuum is 0-105 kPa.
- The engine torque is 40-400 ft. lbs. (54-542 N.m).
- The TP angle is greater than 12 percent.
- The engine speed is greater than 3000 RPM.
- The transmission is not in PARK or NEUTRAL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.