Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Description
2004 Oldsmobile Bravada AWDSECTION Test Description
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Sonoma, 2002 GMC Safari, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers in the diagnostic procedures.
- 2
Listen for a click when the fuel pump relay operates. Command both the ON and OFF states. Repeat the commands as necessary. - 4
This step verifies that the PCM is providing voltage to the fuel pump relay. - 5
This step tests for an open in the ground circuit to the fuel pump relay. - 6
This step determines if voltage is constantly being applied to the control circuit of the fuel pump relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.