SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 690 (BODY REAR END)REPAIR INSTRUCTIONSENDGATE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate.
    2. Fig 1: Endgate & Theft Deterrent Bolt
    GM352939Courtesy of GENERAL MOTORS CORP.
  2. Remove the theft deterrent bolt.
  3. With an assistant, raise the endgate to a 45 degree angle.
    4. Fig 2: View Of Support Cable At Mounting Bolt
    GM388060Courtesy of GENERAL MOTORS CORP.
  4. Remove the cable on each side from the side panel striker bolts.
  5. Remove the endgate from the right side hinge assembly by lifting up on the right side.
  6. With an assistant, remove the endgate from the left body side hinge by sliding to the right and lifting.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.