Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Tools Required
2004 Oldsmobile Bravada AWDSECTION Tools Required
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- J 36660-A Torque Angle Meter
- J 44214 Flywheel Holder
- Apply sealant, GM P/N US 12346004, Canada 10953480, or equivalent, to the engine flywheel retaining bolts.
- Place the engine flywheel in position on the crankshaft.
- Slip one bolt into the engine flywheel washer.
- Install the washer and bolt in a location at the top of its rotation allowing the engine flywheel to hang in position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.