Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 608 (ENGINE MECHANICAL - 2.2L)ENGINE SPECIFICATIONSCYLINDER BLOCK

2004 Oldsmobile Bravada AWD

Cylinder Block

2004 Oldsmobile Bravada AWDSECTION Cylinder Block

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

CYLINDER BLOCK ⁽¹⁾

Application

In. (mm)

Cylinder Bore

Diameter

3.3855-3.3861 (85.992-86.008)

Maximum Taper

.0004 (.010)

Maximum Out-Of-Round

.0004 (.010)

Maximum Piston Height (Below Deck Surface)

.035 (.90)

Maximum Deck Warpage ⁽²⁾

.010 (.254)

⁽¹⁾	For balance shaft bearing specifications, see BALANCE SHAFT & BALANCE SHAFT DRIVE table.

⁽²⁾	Cylinder block may not be machined more than .010 in. (.254 mm). If block requires more than allowable machining to obtain required flat surface, replace engine block.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.