Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 604 (REAR SUSPENSION SYSTEM)SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Section 604 (Rear Suspension System): Specifications
2004 Oldsmobile Bravada AWDSECTION Specifications
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Brake Hose Bracket Bolt | 27 N.m | 20 lb ft |
| Rear Spindle Rods to Knuckle Nut | 150 N.m | 110 lb ft |
| Rear Suspension Strut Shaft Nut | 75 N.m | 55 lb ft |
| Rear Suspension Support Mounting Bolt | 110 N.m | 81 lb ft |
| Rear Wheel Hub to Knuckle Bolts | 75 N.m | 55 lb ft |
| Rear Wheel Spindle Rods to Rear Suspension Support Nut | 140 N.m | 103 lb ft |
| Stabilizer Shaft Insulator Bracket Nuts | 48 N.m | 35 lb ft |
| Stabilizer Shaft Link Nuts | 52 N.m | 38 lb ft |
| Strut Mount to Body Nuts | 45 N.m | 33 lb ft |
| Strut to Knuckle Nuts | 120 N.m | 89 lb ft |
| Trailing Arm Bolt to Body Bracket Bolt | 50 N.m | 37 lb ft |
| Trailing Arm to Knuckle Bolt | 70 N.m + 65 degrees | 52 lb ft + 65 degrees |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.