Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.
  1. Remove the strut-to-body mount nuts (1).
    Fig 1: Identifying Strut Assembly Mounting Nuts & Bolts
    G00379285Courtesy of GENERAL MOTORS CORP.
  2. Raise and support the vehicle.
  3. Remove the tire and wheel assembly.
  4. Remove the stabilizer shaft link from the strut. Refer to STABILIZER SHAFT LINK REPLACEMENT .
  5. Remove the bolt (2) from the brake hose bracket (3) and the strut assembly.
  6. Scribe the strut to the knuckle. See Figure.
  7. NOTE: The knuckle must be retained after the strut-to-knuckle bolts have been removed. Failure to observe this may cause ball joint and/or wheel drive shaft damage.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.