Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 601 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSPINDLE RODINSTALLATION
2004 Oldsmobile Bravada AWD
Spindle Rod: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the spindle rod to the vehicle. See Figure.
- Install the spindle rod to the knuckle.
- Install the spindle rod to knuckle bolt and nut. Tighten the nut to 150 N.m (110 lb ft).
- Install the spindle rod to the rear suspension support.
- Install the bolt and nut to the rear suspension support. See Figure. Tighten the bolt to 140 N.m (103 lb ft).
- Install the rear suspension support. See SUPPORT .
- Install the tire and wheel assembly.
- Lower the vehicle.
- Adjust the wheel toe angle. See SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.