Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ANTI-LOCK BRAKE SYSTEM - 4WAL)DIAGNOSIS & TESTINGDIAGNOSTIC SYSTEM CHECK
2004 Oldsmobile Bravada AWD
Diagnostic System Check
2004 Oldsmobile Bravada AWDSECTION Diagnostic System Check
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2001 GMC Savana Special, 2001 GMC Savana Camper Special, 2001 GMC Savana, 2001 Chevrolet Chevy Express, and 2000 GMC Savana Special. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit reference, see WIRING DIAGRAMS
.
- Install scan tool. If scan tool powers up, go to next step. If scan tool does not power up, diagnose data link communications. See DATA LINK CONNECTORS article in WIRING DIAGRAMS.
- Turn ignition on, with engine off. Using scan tool, attempt to establish communication with PCM and EBCM. If scan tool communicates with control modules, go to next step. If scan tool does not communicate with control modules, go to TEST C: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYMPTOM TESTS.
- Select display DTCs function on the scan tool for PCM and EBCM. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, go to SYMPTOM TESTS .
- If scan tool displays any DTCs which begins with a "U", go to TEST C: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYMPTOM TESTS. If scan tool does not display any "U" series DTC, go to next step.
- If scan tool displays DTC P0500, P0502, P0503, P0562, P0563, P0601-P0607, P1381, P1621, P1627 or P1683, diagnose affected DTCs. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.