Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 596 (REAR SUSPENSION SYSTEM)REAR CROSSMEMBERREAR CROSSMEMBER REMOVAL/INSTALLATIONNOTES
2004 Oldsmobile Bravada AWD
Rear Crossmember Removal/Installation: Notes
2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear auto leveling sensor. See AUTO LEVELING SENSOR REMOVAL/INSTALLATION .
- Remove the rear stabilizer. See REAR STABILIZER REMOVAL/INSTALLATION .
- Remove the charcoal canister. See CHARCOAL CANISTER REMOVAL/INSTALLATION .
- Remove in the order indicated. See Fig 1.
- Install in the reverse order of removal.
- Inspect the wheel alignment and adjust it if necessary. See WHEEL ALIGNMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.