Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 595 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSUPPORT REPLACEMENTINSTALLATION
2004 Oldsmobile Bravada AWD
Support Replacement: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear suspension support on the vehicle. Install the rear suspension support mounting bolts. Tighten the suspension support mounting bolts to 120 N.m (89 lb ft).
- Install the wheel speed sensor wiring harness to the rear support. Install the bolt to the vapor canister. Install the lateral links. Refer to REAR LATERAL LINKS AND TRAILING ARMS REPLACEMENT .
- Install the ABS electrical harness to the lateral links. Connect the electrical connectors to the wheel speed sensors. Install the stabilizer shaft. Refer to STABILIZER SHAFT REPLACEMENT . Install the parking brake cables to the rear support.
- Install the tire and wheel assemblies. Lower the vehicle. Measure the rear wheel alignment. Refer to MEASURING WHEEL ALIGNMENT in WHEEL ALIGNMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.