Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 591 (REAR SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada AWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Torque Specifications
| Application | Specification | ||
|---|---|---|---|
| Metric | English | ||
| Lower Control Arm Ball Joint Stud Nut | |||
|
20 N.m | 15 lb-ft | |
|
3 1/2 flats | ||
|
55 N.m | 41 lb ft | |
| Lower Control Arm (Front) Cam Bolt Nut | 145 N.m | 107 lb-ft | |
| Lower Control Arm (Rear) Cam Bolt Nut | 95 N.m | 70 lb ft | |
| Outer Tie Rod End Stud Nut | |||
|
20 N.m | 15 lb-ft | |
|
160° | ||
|
45 N.m | 33 lb-ft | |
| Rear Crossmember Mounting Nuts (Use New Nuts) | 110 N.m | 81 lb ft | |
| Rear Suspension Adjustment Link to Crossmember Nut | 60 N.m | 44 lb ft | |
| Shock Absorber Lower Mounting Bolt | 220 N.m | 162 lb-ft | |
| Shock Absorber Upper Mounting Bolts | 30 N.m | 22 lb ft | |
| Stabilizer Shaft Insulator (Upper) Clamp Bolt | 65 N.m | 49 lb ft | |
| Stabilizer Shaft Insulator (Lower) Clamp Nut | 95 N.m | 70 lb ft | |
| Stabilizer Shaft Link Nuts | 72 N.m | 53 lb ft | |
| Transverse Spring Mounting Bracket Bolts | 62 N.m | 46 lb ft | |
| Upper Control Arm Ball Joint Stud Nut | |||
|
20 N.m | 15 lb-ft | |
|
250° | ||
|
55N.m | 41 lb ft | |
| Upper Control Arm Mounting Bolt | 110 Nm | 81 lb ft | |
| Wheel Hub Mounting Bolts | 130 N.m | 96 lb ft | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.