SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 537 (AXLE SHAFTS)AXLE SHAFT SPECIFICATIONS
2004 Oldsmobile Bravada AWD

Axle Shaft Specifications

2004 Oldsmobile Bravada AWDSECTION Axle Shaft Specifications
WARNING: This page is about a different car, the 2003 Chevrolet Corvette and 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
AXLE SHAFT SPECIFICATIONS

Application Specifications
Axle Shaft Seal Clamp (1) 0.079-0.118" (2-3 mm)
Plunging Motion Of Inner Joint (2) 8.82-8.98" (224-228 mm)
Seal Clamp (Large) Position - Edge Of Seal-To-End Of Joint Outer Race (3) 0.03" (0.8 mm)
Seal Clamp (Small) Position - Edge Of Seal-To-Edge Of Last Axle Shaft Groove (4) 0.10" (2.5 mm)
(1) Tighten the small seal retaining clamp until the base of omega (ohms) shape has a gap width of 0.079-0.118" (2-3 mm), with a difference in the gap width from side to side no greater than 0.016" (0.4 mm). See Figure .
(2) Measure the distance between the end of the seal and the end of the joint outer race. See Figure .
(3) See Figure .
(4) See Figure
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.