Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (COMPUTER RELEARN PROCEDURES)GENERAL MOTORS (TRUCKS & VANS)CUTAWAY, EXPRESS, RV CUTAWAY & SAVANAELECTRONICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) PROGRAMMING (7.4L)
2004 Oldsmobile Bravada AWD
Electronically Erasable Programmable Read Only Memory (EEPROM) Programming (7.4L)
2004 Oldsmobile Bravada AWDSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming (7.4L)
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
- If VCM was replaced, EEPROM in VCM must be programmed. If EEPROM is not programmed, a DTC will be set.
- Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition switch to ON position. Perform EEPROM programming using Techline® equipment manufacturer's instructions and latest software applicable for vehicle model.
- Once EEPROM is reprogrammed, use scan tool to reset Idle Air Control (IAC) valve. On Calif. models, go to next step. On except Calif. models, go to step 5.
- Once EEPROM is reprogrammed, password learn procedure for anti-theft system must be performed. See PASSWORD LEARN PROCEDURE FOR ANTI-THEFT SYSTEM (7.4L) . Once password learn procedure for anti-theft system has been performed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.NOTE: CKP sensor variation learn procedure should ONLY be performed on except Calif. models. DO NOT perform CKP sensor variation learn procedure on Calif. models. Verify vehicle application by using underhood emission control label. If EEPROM programming fails, ensure all electrical connections on VCM are okay. Check Techline® for latest software. If EEPROM programming still fails, replace VCM.
- Once EEPROM is reprogrammed, CKP sensor variation learn procedure and password learn procedure for anti-theft system must be performed using proper procedure. Once CKP sensor variation learn procedure and password learn procedure for anti-theft system are performed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.