Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 485 (COMMON SPECS & PROCEDURES)AIR CONDITIONINGMANUAL SYSTEMMANUAL A/C TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Manual A/C Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Manual A/C Torque Specifications
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
MANUAL A/C TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| A/C Compressor Mounting Bolts | 37 (50) |
| A/C Compressor Shaft Nut | 13 (17.5) |
| A/C Refrigerant Filter Retaining Nuts | 11 (15) |
| Accumulator-To-Evaporator Fitting | 21 (28) |
| Compressor Discharge Hose-To-Condenser Fitting | 21 (28) |
| Compressor Suction/Discharge Hose-To-Compressor Bolt | 24 (33) |
| Compressor Suction Hose-To-Accumulator Fitting | 35 (48) |
| Evaporator Tube-To-Evaporator Fitting | 21 (28) |
| Heater Inlet Hose Fitting At Intake Manifold | 17 (24) |
| Heater Inlet & Outlet Hoses Bracket Bolt-To-Generator (4.3L) | 18 (25) |
| Heater Inlet & Outlet Hoses Bracket Bolt-To-Generator Mounting Bracket | 37 (50) |
| Throttle Control Cable Bracket Nut | 8.9 (12) |
| INCH Lbs. (N.m) | |
| A/C Compressor Low Pressure Switch | 44 (5) |
| Accumulator Clamp Screw/Bolt | 88 (10) |
| Air Distributor Duct Mounting Screw/Bolt | 17 (1.9) |
| Air Inlet Assembly Mounting Stud | 40 (4.5) |
| Air Temperature Actuator Mounting Screws | 17 (1.9) |
| Blower Assembly Mounting Screw/Bolt/Stud | 40 (4.5) |
| Blower Motor Access Cover Screw/Bolt (Except Utility) | 22 (2.5) |
| Blower Motor Access Cover Screw/Bolt (Utility Only) | 17 (1.9) |
| Blower Motor Mounting Bolts | 40 (4.5) |
| Blower Motor Relay Bracket Mounting Screw/Bolt | 17 (1.9) |
| Blower Motor Resistor Mounting Screw/Bolt | 17 (1.9) |
| Body Harness Connector (C203) Support Bracket Mounting Nuts | 80 (9) |
| Condenser Insulator Retaining Screw/Bolt | 17 (1.9) |
| Compressor Pressure Relief Valve | 80 (9) |
| Electric Actuator (Temperature) Retaining Screw/Bolt | 17 (1.9) |
| Evaporator & Blower Module Heat Shield Mounting Screw/Bolt (Utility Only) | 19 (2.2) |
| Evaporator & Blower Module Mounting Nut | 40 (4.5) |
| Evaporator & Blower Module Mounting Screw/Bolt | 40 (4.5) |
| Evaporator Case Section-To-Blower Case Section Retaining Screw/Bolt | 17 (1.9) |
| Evaporator Tube Clip Screw/Bolt | 17 (1.9) |
| Floor Air Outlet Mounting Screw/Bolt (Pickup Only) | 17 (1.9) |
| Heater Core Access Cover Screws | 17 (1.9) |
| Heater/Vent Module Mounting Nut | 40 (4.5) |
| Heater/Vent Module Mounting Screw/Bolt | 40 (4.5) |
| HVAC Control Assembly Mounting Screw/Bolt (C42 & C60) | 17 (1.9) |
| Intermediate Bracket Bolts | 88 (10) |
| Knee Bolster Bracket Nut | 49 (5.5) |
| Vacuum Control Assembly Retaining Screws | 18 (2) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.