Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 484 (COMMON SPECS & PROCEDURES)ENGINE COOLINGSERVICEENGINE COOLING TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Engine Cooling Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Engine Cooling Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE COOLING TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Coolant Inlet Pipe-To-Cylinder Head Bolt | 37 (50) |
| Knock Sensor | 14 (19) |
| Radiator Bracket Mounting Bolt | 18 (24) |
| Radiator Lower Air Deflector Bolt | 15 (20) |
| Thermostat Housing Bolt | 15 (20) |
| Water Outlet Housing Bolt/Stud (3.8L) | 20 (27) |
| Water Pump Bolt (Long, 3.8L) | 25 (34) |
| Water Pump Bolt (Short, 3.8L) | 16 (22) |
| INCH Lbs. (N.m) | |
| A/C Condenser Mounting Bolt | 58 (6.5) |
| A/C Line Clip-To-Fan Shroud Screw | 40 (4.5) |
| Coolant Heater Bolt | 18 (2) |
| Coolant Inlet Pipe-To-Thermostat Housing Bolt | 89 (10) |
| Coolant Recovery Reservoir Mounting Nut | 29 (3.3) |
| Cooling Fan Blade Nut | 53 (6) |
| Cooling Fan Motor Bolt | 53 (6) |
| Cooling Fan Shroud Bolt | 53 (6) |
| Drive Belt Shield Bolt | 89 (10) |
| Electric Cooling Fan Blade Retaining Nut | 62 (7) |
| Electric Cooling Fan Motor Mounting Screw | 44 (5) |
| Electric Cooling Fan-To-Plenum Mounting Bolt | 58 (6.5) |
| Electric Cooling Fan-To-Radiator Mounting Bolt | 58 (6.5) |
| Heater Pipe Bolt | 89 (10) |
| Radiator Support Bracket Bolt | 80 (9) |
| Surge Tank Bolt | 80 (9) |
| Water Pump Bolt | 89 (10) |
| Water Pump Pulley Bolt (3.8L) | 115 (13) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.