Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 483 (COMMON SPECS & PROCEDURES)AIR CONDITIONINGAUTOMATIC & MANUAL SYSTEMA/C TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
A/C Torque Specifications
2004 Oldsmobile Bravada AWDSECTION A/C Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
A/C TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| A/C Refrigerant Filter Flare Nut | 11 (15) |
| Air Baffle Bolts | 15 (20) |
| Compressor Mounting Bolts | 37 (50) |
| Discharge Hose-To-Compressor Nut | 12 (16) |
| Discharge Hose-To-Condenser Nut | 12 (16) |
| Evaporator Inlet Tube-To-Condenser Bolt | 12 (16) |
| Evaporator Outlet Tube-To-Thermal Expansion Valve Nut | 12 (16) |
| Suction Hose-To-Compressor Nut | 12 (16) |
| Suction Hose-To-Evaporator Outlet Tube Bolt | 12 (16) |
| INCH Lbs. (N.m) | |
| A/C Refrigerant Pressure Sensor | 44 (5) |
| Actuator Screws | 8 (0.9) |
| Air Distributor Cover Screws | 8 (0.9) |
| Air Inlet Housing Screws | 8 (0.9) |
| Blower Motor Mounting Screws | 16 (1.8) |
| Blower Motor Resistor Mounting Screws | 16 (1.8) |
| Center Air Distribution Duct Retaining Nut | (10) |
| Condenser Mounting Bolts | 53 (6) |
| Condenser Tube Clip Bolt | 22 (2.5) |
| Cruise Control Module Mounting Bracket Bolts | 53 (6) |
| Evaporator Inlet Tube Clamp Nut | 89 (3.3) |
| Evaporator Outlet Tube Bracket Bolt | 49 (5.5) |
| Floor Duct Retaining Nuts | 89 (10) |
| Heater Core Cover Screws | 89 (10) |
| Heads Up Display Module Bolts | 18 (2) |
| Heater Core Pipe Retaining Screw | 8 (2) |
| Heater Inlet Pipe Bracket Nut | 62 (7) |
| Heater Outlet Duct Screws | 8 (0.9) |
| Heater Pipe Bolts (LY7 Engine) | 89 (10) |
| HVAC Module Mounting Screws | 8 (0.9) |
| HVAC Module-To-Dash Panel Sound Barrier Nuts | 89 (10) |
| HVAC Mounting Bracket Screws | 16 (1.8) |
| Instrument Panel Compartment Hinge Screws | 35 (4) |
| Knee Bolster Screws | 22 (2.2) |
| Mode Actuator Mounting Bracket Screws | 8 (0.9) |
| Receiver Dehydrator Lower Mounting Bolts | 53 (6) |
| Receiver Dehydrator Upper Bracket Bolt | 53 (6) |
| Right Hand Temperature Actuator Mounting Bracket Screws | 8 (0.9) |
| Service Port | 98 (11) |
| Temperature Door Lever Bolt | 8 (0.9) |
| Thermal Expansion Valve-To-Evaporator Core Mounting Bolts | 28 (3.2) |
| Actuator Retaining Screws, All | 14 (1.6) |
| HVAC Control Module Retaining Screws | 22 (2.5) |
| Temperature Door Lever Bolt | 8 (0.9) |
| Actuator Retaining Screws | 14 (1.6) |
| HVAC Control Module Retaining Screws | 22 (2.5) |
| Temperature Door Lever Bolt | 8 (0.9) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.