Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 480 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENT
2004 Oldsmobile Bravada AWD
Off-Vehicle Deployment
2004 Oldsmobile Bravada AWDSECTION Off-Vehicle Deployment
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Turn ignition off and remove key. Put on safety glasses.
- Short 2 SIR Deployment Harness (SA9207Z-A) leads together by fully seating one banana plug into the other. Connect Pigtail Adapter (SA9414Z) to SIR deployment harness. See Fig 1. Remove driver-side air bag module. See AIR BAG MODULES under REMOVAL & INSTALLATION.
- Place driver-side air bag module on ground (preferably outdoors on paved surface) in center of an area at least 15 feet (4.6 m) in diameter. Ensure that trim cover faces upward. Stretch SIR deployment harness and pigtail adapter from driver-side air bag module to its full length. Place a 12-volt battery near shorted end of SIR deployment harness.
- Connect driver-side air bag module to pigtail adapter. Ensure area around air bag module is clear of people and objects. Verify that air bag module is resting with trim cover facing up.
- Separate 2 banana plugs on SIR deployment harness. Connect SIR deployment harness wires to battery. Driver-side air bag module should deploy immediately. If air bag module does not deploy, go to step 7. If air bag module did deploy, disconnect SIR deployment harness from battery. Short 2 SIR deployment harness leads together. DO NOT touch metal surfaces of air bag module for at least 10 minutes due to heat generated during deployment.
- Wear gloves and safety glasses when handling deployed air bag module. Wash hands with mild soap and water after handling. Dispose of deployed air bag module like any other part. Inspect pigtail adapter and SIR deployment harness for damage after each use. Using Deployment Fixture (SA9413NE) to hold passenger-side and head impact bag modules, repeat deployment procedure using Pigtail Adapter (SA9207Z).
- If air bag modules fail to deploy, ensure that SIR deployment harness is disconnected from battery and that both banana plugs have been shorted together. Disconnect pigtail adapter from air bag module. Temporarily store air bag module with trim cover facing up. Contact manufacturer for additional instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.