Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Zone 9
2004 Oldsmobile Bravada AWDSECTION Zone 9
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Turn steering wheel to place front wheels in straight-ahead position. Turn ignition off and remove key.
- Open glove box to access fuse block. Remove SIR fuse from fuse block. Remove driver-side knee bolster. Remove Connector Position Assurance (CPA) clip from driver-side air bag module Yellow 2-pin connector, located at base of steering column and disconnect connector. See Figure. Remove CPA from passenger-side air bag module connector, located to right of steering column and disconnect connector. See Figure.
- Remove CPA clip from Sensing and Diagnostic Module (SDM), located under passenger-side front seat. See Fig 1. Disconnect SDM connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.