Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
2004 Oldsmobile Bravada AWDSECTION Removal & Installation
WARNING: This page is about a different car, the 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 1 under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Remove grille. Remove front bumper fascia trim retainers. Pull fascia away from radiator support. Remove Connector Position Assurance (CPA) clip from applicable front end discriminating sensor connector and disconnect connector. Remove front end discriminating sensor mounting bolts. See Fig 1. Remove front end discriminating sensor.
- To install, reverse removal procedure. TIghten front end discriminating sensor bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 1 under DISABLING & ACTIVATING AIR BAG SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.