Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Zone 2
2004 Oldsmobile Bravada AWDSECTION Zone 2
WARNING: This page is about a different car, the 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key. Remove SIR fuse (10-amp) from fuse block, located in junction block in center console. See Figure.
- Remove driver-side lower B-pillar trim panel. Remove Side Impact Sensor (SIS) from lower B-pillar. See SIDE IMPACT SENSOR (SIS) under REMOVAL & INSTALLATION. Remove Connector Position Assurance (CPA) clip from Side Impact Sensor (SIS) connector. Disconnect SIS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.