Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)COMPONENT LOCATIONS
2004 Oldsmobile Bravada AWD
Component Locations
2004 Oldsmobile Bravada AWDSECTION Component Locations
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| AIR BAG warning light | Instrument Panel Cluster (IPC) |
| Driver-side air bag module | On steering wheel |
| Electronic Frontal Sensors (EFS) | Underside of radiator support |
| Passenger Presence System (PPS) | Under passenger-side front seat |
| Passenger-side air bag module | Passenger-side instrument panel |
| Seat Position Sensor (SPS) | Under driver & front passenger seats |
| Sensing & Diagnostic Module (SDM) | Under driver seat |
| Side impact air bag modules | Driver & passenger front seat outer seat backs |
| Side Impact Sensors (SIS) | Driver-side & passenger-side lower front doors |
| SIR coil assembly | Under steering wheel |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.