SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 459 (ENGINE CONTROLS - REMOVAL & INSTALLATION - GASOLINE)IGNITION SYSTEMSIGNITION CONTROL MODULEREMOVAL & INSTALLATION
2004 Oldsmobile Bravada AWD

Removal & Installation

2004 Oldsmobile Bravada AWDSECTION Removal & Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine cover. Disconnect the electrical connector. Remove the screws holding the ignition control module and the heat sink to the bracket. Remove the ignition control module and the heat sink. Install the ignition control module and the heat sink on the bracket with the screws. Reconnect the electrical connectors. Install the engine cover.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.