Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Position Sensor
The Throttle Position (TP) sensor is a variable mechanical resistor connected directly to the throttle shaft linkage. The TP sensor has 3 wires connected to it. One is connected to a 5-volt reference voltage supply from PCM, the second is connected to PCM ground and the third is the signal return which is monitored by PCM. The voltage signal from the TP sensor varies from closed throttle (.5-1.0 volt) to Wide Open Throttle (WOT) (4.5-5.0 volts). This signal is used by PCM for determining control of fuel, idle speed, spark timing and converter clutch. Failure in TP sensor circuit should set a related DTC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.