Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Air Temperature Sensor
The Intake Air Temperature (IAT) sensor is a thermistor (temperature sensitive resistor) mounted in the intake manifold. The PCM supplies and monitors a 5-volt signal to IAT sensor through a resistor in PCM. This monitored 5-volt signal is then reduced by resistance of the intake air temperature. Low intake air temperature produces high resistance, while high intake air temperature produces low resistance. By monitoring this voltage, PCM determines manifold air temperature. IAT sensor signal is used to make fuel control calculations according to incoming air density.
Intake air temperature should read close to ambient temperature with engine cold, and rise as underhood temperature increases. After a vehicle has been parked overnight, IAT and ECT sensor signals (resistance and temperature) should be close to the same reading. Failure in IAT sensor circuit (open or short to ground) will cause monitored voltage to swing high or low and should set a related DTC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.