Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 42 (HVAC SYSTEMS - MANUAL)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Compressor Drain Plug | 15 (20) |
| Compressor Hose-To-Accumulator Fitting | 18 (25) |
| Compressor Hose-To-Compressor Bolt | 24 (33) |
| Compressor Hose-To-Condenser Bolt | 18 (25) |
| Compressor Mounting Bolt | 37 (50) |
| Evaporator Hose Fittings | 18 (24) |
| Steering Column Bolts | 19 (26) |
| INCH Lbs. (N.m) | |
| A/C Refrigerant Filter | 11 (15) |
| A/C Refrigerant Pressure Sensor | 44 (5) |
| A/C Service Port | 98 (11) |
| Accumulator Bracket Bolt | 89 (10) |
| Blower Motor Resistor Assembly Screws | 9 (1) |
| Blower Motor Screws | 44 (5) |
| Compressor Hose Bracket Bolt | 89 (10) |
| Compressor Pressure Relief Valve | 80 (9) |
| Condenser-To-Radiator Bolts | 89 (10) |
| Evaporator Clamp Screw | 9 (1) |
| Heater Case Plate Nuts | 89 (10) |
| Heater Core Bracket, Case Cover & Case Shroud Screws | 9 (1) |
| HVAC Control Panel Screws | 18 (2) |
| HVAC Module Assembly Mounting Bracket Nut | 89 (10) |
| Instrument Panel Carrier-To-Cross Vehicle Beam Screws | 18 (2) |
| Mode/Defroster Valve Case Cover Screw | 9 (1) |
| Recirculation Actuator Housing Screws | 9 (1) |
| Temperature Actuator Screws | 18 (2) |
| Vacuum Harness Clip Screw | 9 (1) |
| Vacuum Tank Screw | 18 (2) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.