Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL TANKREMOVAL
2004 Oldsmobile Bravada AWD
Fuel Tank: Removal
2004 Oldsmobile Bravada AWDSECTION Removal
WARNING: This page is about a different car, the 2003 Pontiac Bonneville, 2003 Buick Park Avenue, and 2003 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Drain the fuel tank. See FUEL TANK DRAINING . Raise and support vehicle.
- Remove the filler pipe opening cover. See Figure. Disconnect the fuel fill hose from the fuel fill pipe. Remove the rear suspension support assembly. See appropriate REAR article in SUSPENSION.
- Disconnect the fuel feed pipe and the fuel return pipe. See FUEL LINE DISCONNECT FITTINGS . Disconnect the evaporative emission pipe from the EVAP canister.
- Remove the fuel and EVAP retainer from the frame. Disconnect the fuel sender electrical connector. Disconnect the fuel sender electrical harness from the retainers. Support the fuel tank. Remove the fuel tank strap bolts. Remove the fuel tank.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.